What is a ferrule on a pool cue?

The ferrule is that little white piece just below your tip at the top of your shaft. At its most basic level, the ferrule is your pool cue’s shock absorber. Like a car’s shock absorber, the ferrule provides an additional level of control over your pool cue.

Does a pool cue need a ferrule?

Your pool cue needs to be in tip-top shape at all time. The ferrule is a big part of how successful your shots are ultimately going to be. If the ferrule on your pool cue has seen some form of damage, or is even broken, your shots are going to suffer dramatically as a result.

How do you fix a ferrule pool cue?

Gently remove the old ferrule, remove the excess glue from the stick, sand the tip a bit if uneven, apply glue, and insert the new ferrule. Apply the new tip and clamp it (I usually do it overnight, but that may be overkill). After removing the clamp, shape the tip.

IT IS INTERESTING:  What is the best material for a pool table?

What are the parts of a pool cue?

Pool Cue Anatomy 101

  • TIP. The tip is the part of your pool cue that you use to strike the cue ball. …
  • FERRULE. Right underneath the tip is the ferrule. …
  • SHAFT. The shaft is the top and longest half of a two-piece cue. …
  • JOINT COLLAR. The joint collar is what connects the shaft of the cue to the butt of the cue. …
  • JOINT PIN. …
  • BUTT COLLAR. …
  • FOREARM. …
  • WRAP.

What pool sticks do the pros use?

Best Pool Cues in the World Review – Pros & Cons

  • 1.1 #1 Predator Sport 2 Ice Sport Wrap Pool Cue w/Z-3 Shaft. …
  • 1.2 #2 Cuetec R360 Edge Series 58″ 2-Piece Canadian Maple Billiard/Pool Cues. …
  • 1.3 #3 Tiger pool Cue Icebreaker 2 Break/Jump pool Cue. …
  • 1.4 #4 OB Rift Break pool Cue Rubber Grip Black with Control Break Shaft. …
  • 1.5 #5 Predator Cues – Predator Air 2 Jump.

What should the tip of a pool cue look like?

What should a well maintained pool cue tip look like? A billiard cue’s leather tip should have a rough texture, not smooth. This is to allow the billiard chalk to stick to the leather. A tip should also be convex or “domed”.

Are screw on cue tips good?

You are probably looking to buy a very beginner cue or found screw tips that made you think are the screw on cue tips good. The short answer to that is No. Screw tips are for usually very low-end house cues.

IT IS INTERESTING:  Question: What is the best pool cue tip for draw English?

When should you replace a cue tip?

A good rule of thumb is to change your cue tip every 6 months.

Can you straighten a warped pool cue?

Straightening a warped pool cue is relatively easy, but it may take a long time. … If the tip goes up and down as the pool cue rolls, the stick is warped and will need to be straightened to play properly. Hold the pool cue by the butt and look directly down to the floor at an angle to see exactly where the bend is.

What does the number on a pool cue mean?

What do the numbers next to a pool cue case actually mean? They’re simply a list of how many cues (butts) and how many shafts the case holds. So when you see a cue case advertized as being a 1×2 case, that means it holds one cue butt and two shafts.

What is the end of a pool stick called?

The heavy, lower piece of the cue is the cue butt, and the smaller, narrower end is the shaft. The two cue pieces are attached at the joint; normally a screw rising from butt end’s joint (male) is threaded into a receptacle on the shaft (female), or vice versa.

What is the white ball called in pool?

CUE BALL. (General) The white, unnumbered ball that is always struck by the cue during play.

How much does it cost to re tip a pool cue?

Most professionals charge between $12 and $15 dollars in labor for every pool cue that is repaired, so replacing the tips on your house cues or custom pool cues can save you a bundle when you do it yourself. It’s very easy to do even if you do not have a professional cue lathe.

IT IS INTERESTING:  What is the red ball in pool?

How do I replace a ferrule?

Replace the ferrule if there is a split down the side and a tenon running right through the center of it. Use a lathe or a pair of pliers to remove the ferrule. Squeeze the split on the opposite side and move it around to remove it. Just be careful not to damage the wooden tenon in the middle of the cue stick.

What is the standard cue tip size?

Generally speaking most pool players prefer and 8mm to 8.5mm tip for a 1 & 7/8 pool cue ball, and most snooker players prefer a 9.5mm to 10mm tip for a full size 2 1/16 snooker cue ball. American pool uses an even bigger cue ball so the tip sizes are normally between 12.5 mm and 13.5mm.

8 ball